Portable Devices


If the card is not Plug and Play, you may have to manually configure the card before installation. Locate the CPU cut edge the corner with the pin hold noticeably missing. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. User Password User Password: Use this item to determine the device order the computer used to look for an operating system to load at start-up time. Make sure that your case supports all the features required. Look for the chipset and motherboard model; then browse to the directory and path to begin installing the drivers.

Uploader: Mezigal
Date Added: 16 December 2011
File Size: 39.31 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64009
Price: Free* [*Free Regsitration Required]

The following screens are examples only. Follow the onscreen instructions, confirm commands and allow the computer to restart a few efs to complete the installation.

The illustrations show a 2-pin jumper. Install the edge connector of the add-on card into the expansion slot. You set this value to No to free up an IRQ.

Refer to the table below for information: Some hardware specifications and software items are subject to change without prior notice. OnBoard IR Disabled This item is used to enable or disable the onboard infrared port, and to assign a port address.

New BIOS provides support for new peripherals, improvements in performance, or fixes for known bugs. The second jack is for stereo line-out signal.



Es Password User Password: The installation program begins: Place the motherboard over the mounting brackets and secure the motherboard onto the mounting brackets with screws. The next chapter explains how lwn install the motherboard. Setting Jumpers Use the motherboard jumpers to set system configuration options.

Do not remove any memory module from its antistatic packaging until you are ready to install it on the motherboard. Installing the Motherboard 16 Table A: You may be able to change these settings by making changes to jumpers on the motherboard, or changing the settings in the system Setup Utility.

In this manual, default values are enclosed in parenthesis.

Reset Switch Supporting the reset function requires connecting pin 5 and 7 to a momentarycontact switch that is normally open.

When choosing a processor, consider the performance requirements of the system.

If you enable this item, the system can automatically resume if there is an incoming call on the Modem. EXE by double-clicking the file and then following the instructions on the screen. The oan jack is for microphone. Firstly, some features on the motherboard are implemented by cabling connectors on the motherboard to indicators and switches on the system case.

This file may contain important information to help you install the software correctly.

In the default, S3, the suspend mode is a suspend s740gm-m RAM, i. This concludes Chapter 3. Secure the metal bracket of the card to the system case with a screw. The slot latches are levered upwards and latch on to the edges of the DIMM. But maintains register compatibility and software compatibility with Parallel ATA. Check the box next to the items you want to install.


Avoid using cooling fans with sharp edges on the fan casing and the clips. Run Reboot Setup Windows Vista will block startup programs by default when installing drivers after the system restart.

ECS A740GM-M – 8.0 – motherboard – micro ATX – Socket AM2+ – AMD 740G

Using BIOS 36 PC Health Status On motherboards support hardware monitoring, this item lets you monitor the parameters for critical voltages, temperatures and fan speeds. If the item is set to Delay 4 Sec, then you have to hold the lwn button down for four seconds to cause lsn software power down.

When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surfacemount resistors with the clip of the cooling fan.